Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-39
NSICG60_DEC04
The NetScaler 9000 system port settings are the same as the switch’s port
settings: The port(s) settings are (speed, duplex, flow control, monitoring):
___________________________________________________________
___________________________________________________________
_________________________________________
Enough mapped IP addresses have been configured to support all the
server-side connections during peak times.
• The number of configured mapped IP addresses are: ____
• The expected number of simultaneous server connections is:
[ ] 62,000 [ ] 124,000 [ ] Other
TOPOLOGY CONFIGURATION CHECKLIST
The NetScaler 9000 system’s add route CLI command has been used to
resolve servers on other subnets (see the “Multiple Subnets” section in this
chapter):
The add route command(s) entered were:
____________________________________________________________
____________________________________________________________
________________________________________________
If the NetScaler 9000 system will be in a public-private topology (see the
“Multiple Subnets” section in this chapter), reverse NAT has been
configured on the NetScaler 9000 system.
The add route command(s) entered
were:_______________________________________________________
____________________________________________________________
____________________________________________________________
_________________________________________________
The fail over (high availability) settings configured on the NetScaler 9000
system resolve in a one arm or two-arm configuration. ALL unused
network interfaces have been disabled: _________________________
________________________________________________________