Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-43
NSICG60_DEC04
2.5 Maintaining the NetScaler 9000 System
After initial configuration, the following are the procedures that you need to
perform for maintaining the NetScaler 9000 system:
z Reconfiguring the NetScaler 9000 system
z Restarting the NetScaler 9000 system
z Powering-Off the NetScaler 9000 system
2.5.1 Reconfiguring the NetScaler 9000 system
If you want to review and/or change the NetScaler 9000 system’s
configuration menu settings, enter the following command at the CLI
command prompt:
config ns
The NetScaler 9000 system’s configuration program starts running. Use the
Configuration menu to change or reconfigure the NetScaler 9000 system
settings.
2.5.2 Restarting the NetScaler 9000 system
To restart the NetScaler 9000 system, follow these steps:
1. To reboot the NetScaler 9000 system, enter the following CLI command:
> reboot ns
FIREWALL CHECKLIST
These firewall requirements have been met:
z UDP 161 (SNMP)
z UDP 162 (SNMP trap)
z TCP/UDP 3010 (NetScaler 9000 system GUI)
z HTTP 80 (NetScaler 9000 system GUI)
z TCP 22 (SSH)
z TCP 23 (Telnet)