Instruction manual

Chapter 2 Installation, Configuration and Management
2-44 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_DEC04
2. The LOGIN prompt appears. Use a valid Login name and password to
connect to the NetScaler 9000 system.
The CLI prompt (
>) is displayed.
2.5.3 Powering-Off the NetScaler 9000 system
If you need to power-off the NetScaler 9000 system, ensure that you do it as
follows:
 From CLI prompt
At the CLI prompt, enter the following command:
> shutdown
A series of messages are displayed on the terminal screen indicating that
the NetScaler 9000 system has been halted
 In the NetScaler 9400 model
Press the
ON/OFF switch on the backside of the system once. The green
LED above the switch is turned off.
Note: For more information, refer to Figure 2-22 for the switch’s location.
 In NetScaler 9800-T or NetScaler 9800-SX models
Press the
ON/OFF switch on the backside of the system and HOLD IT
DOWN for four seconds.
Note: For more information, refer to Figure 2-25 for the switch’s location.
At any time after you have powered off the NetScaler 9000 system, you can
restart it by depressing the
ON/OFF switch once. The green LED above the
switch will illuminate.
2.6 Managing the NetScaler 9000 System
This section describes how to manage the NetScaler 9000 system, including:
z Accessing the Command Line Interface (CLI)