Instruction manual

Chapter 2 Installation, Configuration and Management
2-48 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_DEC04
z NetScaler 9000 system GUI applet - see the subsection “Installing the
Java Plug-In from the GUI.”
z NetScaler 9000 system web site - see the subsection “Installing the Java
Plug-In from NetScaler 9000 system’s Web Site.”
Note: If either of the above methods does not work, you can install the
plug-in another way (see the “Installing the Java Plug-In When You
Cannot Install It from the GUI or NetScaler 9000 system Web Site”
subsection).
The following web browsers/platforms have been tested and can be used for
the installation:
z Internet Explorer version 4, 5, or 5.5 on Windows 95/98/2000/NT
z Internet Explorer version 6 on Windows XP Home or Professional
editions
z Netscape 4.51/4.61/4.72/4.75 on Windows 95/98/2000/NT
z Netscape 4.51 on Solaris 5.6/5.7/5.8
z Netscape 4.61/4.72/4.75 on “Red Hat Linux 6.2”
z Netscape 4.77 on Windows 2000/NT, or on Windows XP Home or
Professional editions
z Netscape 6.2 on Windows 98/2000/NT, or on Windows XP Home or
Professional editions
2.6.2.3 Installing the Java Plug-In from the GUI
Proceed as follows:
1. Access the GUI from your web browser:
a. Type the URL in the following format:
http://
IP_address_of_NetScaler 9000 system
WARNING! If there are two NetScaler 9000 systems in a high availability
(fail over) setup, make sure that you do not access the GUI by
entering the IP address of the secondary NetScaler 9000
system. If you do this and use the GUI to configure the