Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-53
NSICG60_DEC04
4. Follow the installation instructions to download java plug-in from the
NetScaler’s web site.
5. After downloading the Java applet, type the following URL in your
browser:
http://IP address of your NetScaler 9000 system
where IP address of your NetScaler 9000 system is the
actual IP address of the NetScaler 9000 system on which the GUI applet
resides.
The Login window is displayed. Proceed with steps 4 - 7 as mentioned in
the “Installing the Java Plug-In from the GUI” on page 48.
6. After the download, the Login window is displayed.
7. Type the Username and Password that allow NetScaler 9000 system
access and then click the Login button.
8. The NetScaler 9000 system GUI screen is displayed in your browser.
Refer to Figure 2-30 on page 52.
Note: If you need to access the NetScaler 9000 system applet’s
documentation, select help topics from the Help menu from the top
right corner of the GUI.
2.6.2.5 Other methods to Install Java Plug-In
If you are using a Netscape or other type of web browser and you cannot
successfully download from the NetScaler 9000 system web site or by
accessing the GUI applet, install the plug-in as follows:
1. In your web browser, enter the URL and port number of your NetScaler
9000 system:
http://
IP_address_of_NetScaler 9000 system:80
where
IP_address_of_NetScaler 9000 system is the NetScaler
9000 system’s IP address.
Note: If there are two NetScaler 9000 systems in a high availability (fail
over) setup, make sure that you do not access the GUI by entering the
IP address of the secondary NetScaler 9000 system. If you do this and
use the GUI to configure the secondary NetScaler 9000 system, any