Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-59
NSICG60_DEC04
Table 2-2 : Table describing Generic Traps and description
Specific Traps
For example, to generate a specific trap enter the following CLI command:
add snmp trap specific 10.102.1.1
In this example, the NetScaler 9000 system is set to display a notice on
10.102.1.1 when the CPU utilization on the system exceeds a predefined
threshold.
Table 2-3 The NetScaler 9000 system can be set to notify following speci fic traps:
Generic trap Name Description
authenticationFailure
A notification is displayed when a
SNMP management application
attempts to access the NetScaler 9000
system and this application does not
have access privileges.
Specific trap Name Description
changeToPrimary A notification is displayed when the
NetScaler 9000 system is in a high
availability configuration becomes the
primary - active NetScaler 9000
system.
changeToSecondary A notification is displayed when the
NetScaler 9000 system is in a high
availability configuration becomes the
secondary - passive NetScaler 9000
system.
cpuUtilization A notification is displayed when the
CPU utilization exceeds the predefined
threshold.
cpuUtilizationNormal This trap indicates that the CPU
utilization has returned to normal.
entityup This trap is sent when the state of the
interface, vserver, or physical service
changes to UP.