Instruction manual

Chapter 2 Installation, Configuration and Management
2-74 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_DEC04
domain noc.company.com
nameserver 169.175.12.23
5. Save the file and exit the editor. Reboot the system to put the change into
effect.
2.6.7 Configuring Clock Synchronization
To enable clock synchronization on your NetScaler system, follow the steps
here to configure your system to utilize NTP (Network Time Protocol) for
clock synchronization.
1. Copy the /etc/ntp.conf file to /nsconfig/ntp.conf.
2. Edit /nsconfig/ntp.conf and add the IP address for the desired NTP server
under the 'server' and 'restrict' entries as indicated in the file.
3. Edit /nsconfig/rc.conf and add the text ntpd_enable="YES".
4. Reboot the system to apply your changes.
Note: If you do not have an NTP server to use for time synchronization,
listings of public, or open access, NTP servers can be found at the
official NTP site at http://www.ntp.org under the ‘Public Time
Servers List’ pages. Be sure to read and adhere to the ‘Rules of
Engagement’ page linked to on these pages before selecting a NTP
server from the lists.
2.6.8 Using NetScaler 9000 Series Logging
The NetScaler system allows you to customize the logging of system events
and SSL VPN access events, according to site needs. You can direct these
logs either to local files on the NetScaler or to external log hosts. This section
explains how to customize these logging aspects.
Note: After editing files to customize your NetScaler system's logging as
discussed in this section, you must restart the system to activate the
changes.