Operation Manual

3
39
COMFORT
Returning the backrest of the
bench seat to its initial position
Push the backrest towards the rear
and engage it on mounting B .
Take care not to trap the seat belts,
in particular between the seat back
and the mounting B.
Check that the backrest has engaged
correctly.
Rear head restraints *
The rear head restraints can be re-
moved and have two positions:
- high, position for use.
- low, storage position.
To raise the head restraint, pull it up-
wards.
To lower it, press lug A then the head
restraint.
To remove it:
- tilt the seat back slightly,
- move the head restraint to the high
position,
- press lug A pulling the head
restraint upwards at the same time.
To refi t it:
- tilt the seat back slightly,
- engage the rods of the head
restraint in the openings.
To reach the low position, press lug A .
Folding the backrest of
the bench seat
The seat backrest is folded from
the rear of the vehicle, with the boot
open:
- check that the seat belt is
positioned correctly on the
side of the seat back to avoid
damaging it,
- place the head restraints in the
low position (see "rear head
restraints"),
- while folding the seat backrest,
pull the strap(s) A , located
behind the seat back.
* According to version.