Operation Manual

3
53
CO
MF
O
R
T
) Press the control located under the
front end of the armrest to release it.
) Move it to the low position.
) Raise it notch by notch to reach the
desired position.
To place the armrest in the vertical po-
sition, raise it and push it backwards
beyond the point of resistance.
Head restraint height adjustment
) To raise the head restraint, pull it up-
wards.
) To remove the head restraint, press
the lug A and pull the head restraint
upwards.
) To put the head restraint back in
place, engage the head restraint
stems in the openings keeping them
in line with the seat back.
) To lower the head restraint, press
the lug A and the head restraint at
the same time.
The head restraint is fi tted with
a frame with notches which pre-
vents it from lowering; this is a
safety device in case of impact.
The adjustment is correct
when the upper edge of the
head restraint is level with the
top of the head.
Never drive with the head re-
straints removed; they must be
in place and adjusted correctly.
A
d
j
ustin
g
the armrest
Additional ad
j
ustments