Operation Manual

108
IX
D R I V I N G
Displays on the instrument panel
- The selector position is displayed
in the instrument panel, on the left
on multifunction screens A and C
and on the right on the NaviDrive
multifunction screen.
- A back-lit position grille associ-
ated with the selector shows the
position selected.
Moving off
When the ignition is on, lighting of
the service warning lamp, accom-
panied by an audible signal and
the message "Gearbox faulty" in-
dicates a malfunction.
Consult a CITROËN dealer.
For safety:
 Position N can only be disen-
gaged if you are pressing the
brake pedal.
 If the gearbox is in position N
but the selector position is diffe-
rent, reposition the selector on N
in order to be able to start.
 To start the engine, the selector
must be in position N .
 Press fi rmly on the brake pedal.
 Operate the starter.
 When the engine is running,
place the selector on R , A or M
as desired.
 Check, in the instrument panel,
the position engaged.
 Release the brake pedal and
accelerate.
If the selector is not in position N ,
and/or if the brake pedal is not
pressed, the corresponding warning
lamp(s) are displayed and a mes-
sage informs you that at least one of
these two conditions is not met.
In this case, the engine will not start,
recommence the above procedure.
Engaging reverse gear
To engage reverse gear, move the
selector to R .
Only attempt to select reverse gear
when the vehicle is stationary.
If the vehicle is moving rapidly, if an in-
advertent attempt to engage reverse
gear is made, the warning lamp N will
fl ash and your vehicle will go auto-
matically into neutral. To re-engage a
gear, you have only to reposition the
selector on A , M or R .
Reverse gear