Operation Manual

138
XI
P R A C T I C A L I N F O R M A T I O N
 Go to a CITROËN dealer
as soon as possible. You
must tell the technician
that you have used the kit.
Have the tyre inspected by the
technician, who can then advise
you whether it can be repaired or
should be replaced.
 Connect the compressor's elec-
tric plug to the vehicle's 12 V
socket.
 Start the vehicle again and leave
the engine running.
The expiry date of the fl uid is
indicated on the cartridge.
The sealant cartridge is de-
signed for single use; even if only
partly used, it must be replaced.
After use, do not discard the car-
tridge into the environment, take
it to an authorised waste disposal
site or a CITROËN dealer.
Do not forget to obtain a new
sealant cartridge, available from
CITROËN dealers.
 Adjust the pressure using the
compressor (to infl ate: switch B in
position "I" ; to defl ate: switch B in
position "0" and press button E ),
in accordance with the vehicle's
tyre pressure label (located on the
left hand door aperture).
A loss of pressure indicates that
the puncture has not been fully
plugged; contact a CITROËN
dealer for assistance.
 Remove and stow the kit.
 Drive at reduced speed (50 mph
[80 km/h] max) limiting the dis-
tance travelled to approximately
120 miles (200 km).
Removing the cartridge
 Stow the black pipe.
 Detach the curved base of the
white pipe.
 Support the compressor verti-
cally.
 Unscrew the cartridge from the
bottom.
Beware of fl uid leaking.