Operation Manual

186
In the event of a breakdown
F Switchonthecompressorbymoving
the switch B to position "I" until the tyre
pressurereaches2.0bars.
 Thesealantisinjectedintothetyreunder
pressure;donotdisconnectthepipefrom
thevalveduringthisoperation(riskof
splashing).
Ifafteraround5to7minutesthe
pressureisnotattained,thisindicates
thatthetyreisnotrepairable;contact
aCITROËNdealeroraqualified
workshopforassistance.
F Removethekitandscrewthecapbackon
thewhitepipe.
 Takecaretoavoidstainingyourvehicle
withtracesoffluid.Keepthekittohand.
F Driveimmediatelyforapproximately
threemiles(fivekilometres),atreduced
speed(between15and35mph(20and
60km/h)),toplugthepuncture.
F Stoptochecktherepairandthetyre
pressureusingthekit.
Tyre under-ination detection
Afterrepairofthetyre,thewarning
lampwillremainonuntilthesystemis
reinitialised.
Formoreinformationonunder-inflation
detection,refertothecorresponding
section.
2. Ination
F Turn the selector A to the "air"
position.
F UncoiltheblackpipeHfully.
F Connecttheblackpipetothe
valveofthewheel.