Operation Manual

VI
113
FITTINGS
The roller has a moving fl ap to
avoid interference with the second-
row passengers when the seats
are in the "reclined" position.
) Engage the lug on the left of the
roller in notch C .
) Pass the right-hand end above
the third-row armrest.
) Engage the lug in notch D .
) Pull the seat belt(s) so that they
reel out without locking.
) Pull out the blind and engage
the guides into the rails on the
pillars.
) Lock the seat(s) in position.
Installing the roller
) Reel in the blind, then remove
the roller from its initial position.
) Position the roller, with the blind
pull bar uppermost, fl ap down-
ward.
) Fold the concertina boards.
Removing the roller
) Push the fl ap towards the seat
backrest.
) Lift the concertina board by tak-
ing it at the side, then position it
vertically.
) Release the seat by pulling the
strap E .
)
Push the backrest towards the front.
) Proceed in reverse order to in-
stalling.
Position 3
7-seat confi guration; stowed behind
the third row seats when these are
folded away.
Installing the roller
) Fold the concertina boards.
) Position the roller, with the blind
pull bar uppermost, fl ap down-
ward.
) Engage the lug on the left of the
roller in notch C .
) Pass the right-hand end above
the third-row armrest.
) Engage the lug in notch D .
Removing the roller
) Proceed in reverse order to in-
stalling.
Position 2
7-seat confi guration; installed be-
hind the third-row seats when these
are folded away. This position con-
ceals objects stowed in the boot
from outside view.
The roller can only be stored when
the seats are folded away.
You can position the concertina
board vertically to lodge a bulky ob-
ject in the boot well.