Specifications

111
III
B
C
D
C
E
CHILD RESTRAINTS
The ISOFIX fastening
system
Front (saloon and Tourer)
The ISOFIX system is made up
of 3 rings for the front passenger
seat:
2 rings
A located between the
backrest and the seat cushion,
with the ISOFIX logo.
A third ring B xed in the lower
section of the rear of the back-
rest.
Rear (saloon)
The ISOFIX system is made up of
3 rings for each side rear seat :
2 lower rings
C located between
the backrest and the seat cushion,
with the ISOFIX logo.
•
•
•
One top ring D xed on the rear
shelf, concealed under a ap with
the TOP TETHER logo behind
the head restraint.
Rear (Tourer)
The ISOFIX system is made up of
3 rings for each side rear seat :
2 lower rings
C located between
the backrest and the seat cushion.
They are approximately 28 cm
apart and have the ISOFIX logo.
One top ring E, concealed under
a ap with the TOP TETHER
logo.
•
•
•
The ISOFIX child seat
fastening system
ISOFIX child seats have 2 latches
which are easy to anchor on the 2
lower rings A or C.
Some ISOFIX child seats also
have an additional belt which is
attached to the upper ISOFIX
ring D (saloon) or E (Tourer) of
the side rear seats.
To attach the top belt, raise the
head restraint of the vehicle seat,
then pass the buckle between the
rods. Next x the buckle on the
top belt D or E and tension the top
belt.
This xing system is intended for
children weighing up to 18 kg.
The ISOFIX child seats which can
be installed in your vehicle are
indicated in the table on the next
page.