Operation Manual

103
7
TROUBLESHOOTING
Changing a wheel
- If a pressure of at least
1.5 bars
is not
reached within
5 minutes
:
 disconnect the compressor from the
valve and the 12V accessories socket,
 move the vehicle about 10 metres
forward to distribute the filling liquid
inside the tyre,
 repeat the inflation procedure.
- If a pressure of at least 1.8 bars is not
reached within
10 minutes
:
 stop the repair procedure ; the tyre
is too badly damaged and cannot be
repaired,
 contact a CITROËN dealer.
- If the tyre has been inflated to a pressure
of
3 bars
, start driving immediately.
After having driven for approximately
10 minutes, stop the vehicle and check the
tyre pressure again.
Restore the correct pressure if necessary,
and contact a CITROËN dealer as soon as
possible.
You must inform the technician that you
have repaired the tyre with the puncture
repair kit and give him the user guide.
Checking and restoring the pressure
To check and restore the pressure of a tyre,
the compressor must be used, as follows :
- disconnect the tube
I
,
- connect it directly to the tyre valve,
the bottle will then be connected to the
compressor and the filling liquid will not
be injected.
If it is necessary to deflate the tyre :
- connect the tube
I
to the tyre valve,
- press on the yellow button, located in the
centre of the compressor’s switch
F
.
Replacing the puncture repair bottle
Disconnect the tube
I
.
Turn the empty bottle in the opposite
direction to the arrows and lift it out.
Insert the new bottle and turn it in the
direction of the arrows.
Reconnect the tube
I
and connect the
tube
B
in its slot.
The puncture repair bottle contains
ethylene glycol, which is harmful if
ingested and can be irritating for the eyes.
Keep this product out of the reach of
children.
After use, do not throw the used bottle
away, take it to a CITROËN dealer or an
authorised disposal facility.