Operation Manual

17. PITCH BEND BUTTONS
(-) PITCH BEND button – The (-) pitch bend function creates a momentary “Slow Down” in the CD’s
pitch speed (Beats per minute - BPM) when the PITCH function is activated. This function allows the beats
between two CD’s or any other music source to match.
This is a momentary function. When the button is depressed the pitch speed will automatically return to
PITCH SLIDER'S selected pitch. Holding down this button will give a maximum of -16% pitch. Be sure to
remember that this function is a momentary pitch adjustment, for a more precise adjustment use the
PITCH SLIDER to match the BPM’s with another playing music source.
(+) PITCH BEND button – The (+) pitch bend function creates a momentary “BUMP” in the CD’s pitch
speed (Beats per minute - BPM) when the PITCH function is activated. This function allows the beats
between two CDs or any other music source to match. This is a momentary function. When the button is
depressed the pitch speed will automatically return to PITCH SLIDER'S selected pitch. Holding down this
button will give a maximum of +16% pitch. Be sure to remember that this function is a momentary pitch
adjustment, for a more precise adjustment use the PITCH SLIDER to match the BPM’s with another
playing music source.
18. LOOP IN button – This function allows you to set the starting point of a loop.
19. LOOP OUT button – This button is used to set the ending point of a loop. A loop is started by pressing the IN
BUTTON, pressing the OUT BUTTON sets the loop ending point. The loop will continue to play until the OUT
BUTTON is pressed once again.
20. RELOOP button – If a LOOP has been made, but the CD Player is not actively in LOOP mode (a loop is not
playing), pressing the RELOOP BUTTON will instantly reactivate the LOOP mode. To exit the loop, press
the LOOP OUT BUTTON.
21. PITCH PERCENTAGE SELECTOR – Choose from pitch percentages of 4%, 8%, and 16%.
22. CONTROL START socket – These sockets are to connect to a mixer using a 3.5mm jack plug to give
remote start capability. When the switch contacts are shorted the respective unit will play, and similarly when
the switch contacts are open the player will be in pause mode.
23. CONTROL connector – Connect this connector to the REMOTE connector on the main unit using the
included control cord.
GENERAL FUNCTIONS CONTROL UNIT
4