Operating instructions

™
25. FX SEL. BUTTON － This arrow is used to select the FX to activate and press the button to select the FX
between SCRATCH/FILTER/ECHO/ TRANS and SKID/PHASE/FLANGER/PAN to activate. The LED
above the FX SEL. Button will indicate which FX are selected.
26. SCRATCH/SKID BUTTON － This button is used to activate and deactivate the SCRATCH effect, when
the FX SEL.LED is green. This button is used to activate and deactivate the SKID effect, when the FX
SEL. LED is blue. When SCRATCH or SKID effect is activated, you can tune the TIME PARAMETER
button to adjust the start time and tune the RATIO PARAMETER to adjust the stop time. If you want to
fine adjust the time parameters, you can press TIME PARAMETER or RATIO PARAMETER button then
rotate the JOG wheel. Hold the button to active scratch cue function and SCRATCH LED is red.
SCRATCH CUE
IN PLAYBACK MODE:
While in play mode and when the touch sensitivity function is active, the JOG WHEEL can be used to
return the unit to last cue point. Simply touch the JOG WHEEL and unit will immediately return to the last
set cue point and playback without music interruption.
IN CUE MODE:
While in cue mode and when the touch sensitivity function is active, tapping on the JOG WHEEL can be
used to start playback. The unit will continue to playback until the JOG WHEEL is released. One the JOG
WHEEL is released the unit will return to the last point.
27. FILTER/PHASE BUTTON － This button is used to activate and deactivate the FILTER effect, when the
FX SEL. LED is green. This button is used to activate and deactivate the PHASE effect, when the FX SEL.
LED is blue. The TIME PARAMETER button is used to adjust the FILTER/PHASE effect’s scan time in
mini-second. The RATIO PARAMETER button is used adjust the FILTER/PHASE effect’s frequency
sweeping range.
28. HOLD BUTTON － This button allows you to set and lock any new parameters you set to the FX. This
button will glow red when the hold function is activated. If the hold function is not selected any changes to
the effect parameters will be momentary.
29. ECHO/FLANGER BUTTON – This button is used to activate and deactivate the ECHO effect, when the FX
SEL. LED is green. This button is used to activate and deactivate the FLANGER effect, when the FX SEL.
LED is blue. The TIME PARAMETER button is used to adjust the ECHO/FLANGER effect’s scan time in
mini-second. The RATIO PARAMETER button is used adjust the ECHO/FLANGER effect’s frequency
sweeping range.
30. TRANS/PAN BUTTON － This button is used to activate and deactivate the TRANS effect, when the FX
SEL. LED is green. This button is used to activate and deactivate the PAN effect, when the FX SEL. LED
is blue. The TIME PARAMETER button is used to adjust the TRANS/PAN effect’s scan time in mini-second.
The RATIO PARAMETER button is used adjust the TRANS/PAN effect’s frequency sweeping range.
31. AUDIO OUT-SOCKETS － The music-signal of these sockets is analogue. Connect the output to the
respective input of your mixer.
32. DIGITAL OUT-SOCKET － The music-signal of this socket is digital. Connect the output to the respective
input of a digital amplifier for example.
33. RELAY SOCKET － Via the RELAY SOCKET, two CD players can relay play. If you connect with a mixer
which supporting fader start, you can also relay play via mixer’s cross-fader.
34. POWER SWITCH － Press this button to start operation.
35. AC CONNECTION
－ Plug the power supply cable in here.
31 32 33 34 35