Operation Manual

STORING A CUE POINT:

Once you have set your CUE Point, you may store your cue point in one of the CUE BANK BUTTONS.

Either a CUE POINT or a Loop can be stored into a CUE BANK BUTTONS.

(1) Press the MEMORY BUTTON as right Figure. The Memory LED will

glow indicating the store memory function has been activated. You

may now press any one of the 4 CUE BANK BUTTONS to store

your cue point into memory. After pressing one of the CUE BANK

BUTTONS, the corresponding CUE BANK Button LED will flash.

The LED on the CUE BANK BUTTON will turn on and will remain lit

indicating either a loop or cue point is stored in memory. The

MEMORY LED will turn off.

(2) Repeat the above steps to store up to 4 Cue Points. Once your 4

cue points have been stored you may access them at any time.

During playback the cue points will instantly start playback from that

point without any music interruption. Please note in order to access

these cue point, the music source device used to create the cue

points must be in the SD slot or USB port.

TO SAVE CUE BANK POINTS:

To save all your setting into music source device, just press and hold

down the MEMORY BUTTON for about 2 seconds. When the CUE

BANK BUTTONS has been stored properly the LCD will show “CUE

Backup” for about 2 seconds.

RECALL THE CUE MEMORY:

1) Be sure a music source device is loaded into the drive.

2) Press the MEMORY BUTTON so the memory LED turns on.

3) When you select a track or folder the cue point will be loaded automatically, the player will be ready once

the cue points are all loaded. The MEMORY BUTTON LED will flash during recall CUE BANK BUTTONS.

PERATI