User manual

Citronic Limited User manual
Page 7 of 10
Cartridge Replacement
To replace the cartridge in the headshell, follow the
instructions below:
When installing a cartridge, refer to the operating
instructions of that cartridge.
During installation, attach the stylus protector to guard
the stylus tip from damage.
To aid assembly use the slot provided at the rear of
the turntable (feature 20)
a) Using a pair of fine electronic pliers, carefully
remove each of the four wires in turn from the back of
the cartridge.
b) Unscrew the two cartridge mounting screws and
withdraw the old cartridge.
c) Install the new cartridge and tighten with the
screws provided so that they are central in the
headshell slot.
d) Connect the lead wires to the cartridge terminals.
The terminals of most cartridges are color-coded.
Connect each lead wire to the terminal of the same
color.
White (L+) Left channel+
Blue (L-) Left channel-
Red (R+) Right channel+
Green (R-) Right channel-
Technical Specification
Motor
8 pole 2 phase brushless DC
Drive Direct Drive
Pitch +/- 10%
Starting Torque More than 1kgf.cm
Braking system Electronic brake
Braking Time Less than 1 sec.
Starting Time Less than 1 sec.
Braking Time Less than 1 sec.
Tracking force adjustment range 0 – 4g
Effective arm length 230.5mm
Power supply AC 115 - 230V, 50/60Hz
Power consumption 12 Watts
Dimension (WxDxH) 450 x 350 x 146 mm
Weight 9.6 Kgs
Output as per cartridge fitted 1.5 – 3.6 mV