Installation Guide
3
Power Consumption
The above values are excluding heater consumption which is variable and depending on
conguration settings. Default value is 220 mA at 12VDC but can be congured in 20 mA
intervals from minimum 120 mA to maximum 300 mA. When the heater is set in automatic
mode, the heater will be activated when the internal temperature of the reader is below +1°C,
the heater will automatically deactivate when the internal temperature exceeds +5°C.
Depending on the heater consumption setting the time it will take for the reader to exceed +5°C
will vary- a higher power consumption setting will reduce the time required to heat the reader.
Current draw (idle) is dened as reader connected to power, no LED’s lit, buzzer is not
sounding and no reading of credential or key pressing is processed by the reader. Current
draw (peak) is dened as reader powered with both backlight and LED frame lit (Yellow),
buzzer is sounding and reader is reading a credential while simultaneously a key pressing is
processed.
Model Feature
Brightness Current draw (idle)
Model: Civintec Global Cidron LED-Bar Backlight 12VDC 24VDC
SC93100-MDEB
STD 13.56MHz/125KHz/2.4GHz with keypad
Low Low 90 mA 47 mA
Medium Low 90 mA 47 mA
SC93110-MDEB
STD 13.56MHz/125KHz/2.4GHz without
keypad
Low Low 90 mA 47 mA
Medium Low 90 mA 47 mA
SC93200-MDB
SLIM 13.56MHz/2.4GHz with keypad
Low Low 34 mA 18 mA
Medium Low 34 mA 18 mA
SC93210-MDB
SLIM 13.56MHz/2.4GHz without keypad
Low Low 34 mA 18 mA
Medium Low 34 mA 18 mA