Operation Instruction

SPECIFICATION

Remote Control Outlet

Model: RCS-13U+RC-14U

Voltage: 125VAC, 60Hz

Max.load: 15A Resistive or General purpose, 10A/1250W Tungsten, TV-5, 1/2HP

Remote battery: 1PC CR2032 3V

Radio frequency: 433.92MHz

Transmitter duty cycle<10%

Receiver category: Class 3

Operation distance:about 80 feet in open area

DIAGRAM

OPERATION

1.Put battery in the transmitter.

Open battery cover of the transmitter and put 1PC CR2032 3V battery in it.Then press button of the transmitter to check

whether it can work. If LED indicator turns on, it means this transmitter works well.

2.Plug the receiver into an outlet.

This receiver is a “grounded” device. It is only intended for use with a three-pronged grounded outlet.

3.Pairing with transmitter

a.Once the receiver is plugged into the outlet. LED indicator in the front right corner of the receiver is slowly flash.

Enter into leaning mode.

Please note: The receiver will exit leaning mode after 29 seconds without any operation. Then please pull the

receiver out and put it into the outlet again to pair.

b.Press transmitter’s 1 channel ON, 2 ON or 3 ON to pair with receiver. Once successfully, LED indicator of receiver

stops slow flashing and keeps on.

c.Now you can turn this receiver on/off by pressing selected ON/OFF channel. LED indicator of the receiver turns on,

it means power is on. In contrast, power is off.

4.Clear selected channel

Pull the receiver out and put it into power outlet (LED indicator is slowly flash as channel selection mode), then press

OFF key of selected channel. LED indicator of receiver shows fast flashing (3-4 seconds), which means selected

ON/OFF channel is cleared. After that, receiver returns to channel selection mode. Total time is 29 seconds.

5.Clear all selected channels

a.Pull the receiver out and put it into power outlet (LED indicator is slowly flash as channel selection mode), then

press OFF key of ALL ON/OFF channel. LED indicator of receiver shows fast flashing (3-4 seconds), which means all

selected ON/OFF channels are cleared. After that, LED indicator turns off.

b.Unplug the receiver.

c.The receiver should now be unpaired with the remote.

HELPFUL TIPS

1.The transmitted coded pattern is Random/Learning code. Repeat probability is 1/1,048,575.

2.The transmitter can control up to 3 ON/OFF channels. Each channel can control one certain receiver. Or if one

channel pair multiple different receivers, then this channel can turn these different receivers on/off simultaneously.

3.ALL ON/OFF channel can turn the receivers of 1, 2 and 3 channels on/off simultaneously.

4.One receiver can memorize maximum 10 ON/OFF channels. If pair the eleventh channel, the first paired channel

will be cleared.

WARNINGS

PAGE 1
Operation Instruction SPECIFICATION Remote Control Outlet Model: RCS-13U+RC-14U Voltage: 125VAC, 60Hz Max.load: 15A Resistive or General purpose, 10A/1250W Tungsten, TV-5, 1/2HP Remote battery: 1PC CR2032 3V Radio frequency: 433.92MHz Transmitter duty cycle<10% Receiver category: Class 3 Operation distance:about 80 feet in open area DIAGRAM OPERATION 1.Put battery in the transmitter. Open battery cover of the transmitter and put 1PC CR2032 3V battery in it.
PAGE 2
Risk of Electric Shock - Keep children away. - Do not use in wet locations. - Do not plug two or more timers together. - Always ensure the plug of any appliance is fully inserted into the timer outlet. - If cleaning of the timer is required, remove from mains power and wipe timer with a dry cloth. - Do not immerse timer in water or any other liquid. - For indoor use only. Risk of Fire - Don't plug in an appliance where the load exceeds rated capacity. - Do not use with extension cords.