User guide

NOTE:
1. FOR MOUNTING, A FLAT SURFACE MUST BE PROVIDED ACROSS THE
ENTIRE LENGTH OF THE BRACKET. THE VALVE BODY BECOMES SECURE 
TO BRACKET, WHEN BRACKET IS TIGHTENED IN TO POSITION.
IF THE VALVE HAS A MANUAL OPERATOR, A HOLE MUST BE MADE
THROUGH THE MOUNTING SURFACE FOR THE OPERATOR STEM.
RETAINING CAP
NAMEPLATE
COVER
YOKE
HOUSING
FLUX PLATE
(NOT PRESENT IN
ALL CONSTRUCTIONS)
SOLENOID BASE
SUB ASSEMBLY
(OPTIONAL)

MOUNTING BRACKET
(FOUR POSITIONS)
TWO SELF-TAPPING
SCREWS PROVIDED
CORE SPRING
(WIDE END IN CORE FIRST, CLOSED END
PROTRUDES FROM TOP OF CORE)
CORE ASSEMBLY
BODY GASKET
BODY
(BRASS)
DISC HOLDER
ASSEMBLY
DISC SPRING
BODY GASKET
END CAP
END CAP
BODY GASKET
DISC SPRING
DISC
DISC HOLDER
BODY
(ST. ST.)
BODY GASKET
CORE ASSEMEBLY
CORE SPRING
(WIDE END IN CORE FIRST, CLOSED END
PROTUDES FROM TOP OF CORE)
PLUGNUT/CORE TUBE
SUB-ASSEMBLY
BONNET GASKET
BONNET
SOLENOID ENCLOSURE
RETAINING CAP
PARTS INCLUDED IN
SPARE PARTS KITS
MANUAL OPERATOR
SCREW TYPE
(MS)
MANUAL OPERATOR
PUSH TYPE
(MO)
*
SLEEVE

INSULATING WASHER
(OMITTED WHEN MOLDED
COIL IS USED)
COIL
INSULATING WASHER
(OMITTED WHEN MOLDED
COIL IS USED)
SLEEVE
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
(OPTIONAL)
MOUNTING BRACKET
(SEE NOTE
CLA-VAL
Copyright Cla-Val 2008 Printed in USA Specifications subject to change without notice.
P.O. Box 1325 • Newport Beach, CA 92659-0325 • Phone: [phone] • Fax: [phone] • E-mail: [e-mail] • Website cla-val.com
©
N-V5291 (R-1/08)