User guide

CLA-VAL
Copyright Cla-Val 2008 Printed in USA Specifications subject to change without notice.
P.O. Box 1325 • Newport Beach, CA 92659-0325 • Phone: [phone] • Fax: [phone] • E-mail: [e-mail] • Website cla-val.com
©
Torque Chart
Part Name
terminal block screws
socket head screw
center screw
Torque Value in inch-Pounds
10 ± 2
15 - 20
5 ± 1
Torque Value in Newton-Meters
1,1 ± 0,2
1,7 - 2,3
0,6 ± 0,1
Open Frame Solenoid
with 1/4" Spade Terminals
tapped hole for
#10-32 grounding screw
(not included)
See
torque chart
above
Open-Frame Solenoid
with Screw Terminals.
Socket head screw is 
used for grounding.
Screw terminal 
adapter
terminal
block
screw
socket head
grounding screw
(5/32" hex key wrench)
Open-Frame Solenoid
with DIN Terminals.
gasket
DIN terminal
adapter
socket head screw
(5/32" hex key wrench)
Junction box Solenoid
with 1/4" Spade Terminals
or Screw Terminals
screw terminal block
(see note)
junction box gasket
junction box with
1/2" conduit connection 
and grounding terminal
socket head screw
(5/32" hex key wrench)
cover screw
cover
cover gasket
grounding screw
and cup washer
See 
torque chart
above
gasket
DIN terminal
adapter
connector
gasket
gland nut
gland gasket
washer
center screw
Open-Frame Solenoid
with DIN Terminal
Plug Connector
Note:
Junction box with screw terminals
shown. With screw terminal
block removed, remaining parts
comprise the junction box for 
spade terminal construction.
See 
torque chart
above
socket head screw
(5/32" hex key wrench)
DIN connector
terminal block
(see note 2)
connector cover
(see note 1)
Notes:

1. Connector cover may be
rotated in 90˚ increments from
position shown for alternate
postion of cable entry.

2. Refer to markings on DIN
connector for proper
electrical connections.
Indicates that these parts are included
in DIN plug connector Kit No. K236-034
*
*
*
*
*
*
*
Figure 4. Open - frame solenoids
Figure 5. Open - frame solenoids
N-V6583 (R-1/08)