- Clam Corporation Fish Trap Guide BP2 Instruction Manual

ManualsBrandsClam Corp ManualsCamping EquipmentFish Trap Guide 8060

Clam Corporation, Inc. Manual – 102178

Model No.

- 8060 -

p/n 108306

Specifications

Height: 60” (21” packed)

Width: 35 inches

Depth: 81” (35” packed)

Weight: 45 lbs.

- Clam Customer Service Information -

NOTICE!! Once used, this shelter cannot be returned to the store. If you have a

Warranty Claim, please contact Clam Corporation Customer Service by email

inquiry or direct by calling:

Customer Service Hrs: - 8am to 4pm, Mon. - Fri. Central Standard Time

Clam Corporation, Inc.

600 Clydesdale Trail

Medina, MN 55340

Phone - 763-231-4120

Fax - 763-231-4121

Website – www.clamcorp.com

Email – www.customerservice@clamcorp.com

Summary of content (8 pages)

PAGE 1
Model No. - 8060 p/n 108306 Specifications ŀ ŀ ŀ ŀ Height: 60” (21” packed) W idth: 35 inches Depth: 81” (35” packed) W eight: 45 lbs. - Clam Custo mer Service Information NOT ICE!! Once used, this shelter cannot be returned to the store. If you ha ve a Warrant y Clai m, please contact Clam Corporation Custome r Se rvice by emai l inqui ry or di rect by calli ng: ŀ ŀ Custo mer Service Hrs: - 8a m to 4p m, Mon. - Fri. Central Standard Time ŀ ŀ ŀ ŀ Phone - 763-231-4120 Clam Corporation, Inc.
PAGE 2
- Step One - 2
PAGE 3
- Step Two - 3
PAGE 4
- Step Three Slide the Canopy Hoop Poles onto the Canopy Poles until the spring buttons engage the holes near the ends. Lean the Canopy Hoop Poles down and locate the Tent.
PAGE 5
- Step Four Drape the Tent over the supported hoops then go inside and spread out the Canopy Hoop Poles, attaching the Roof Velcro as you go. Feed the length of the Porch Hoop Pole through the Porch Hoop Sleeve sewn on the Tent. Slide the Porch Hoop Pole onto the Porch Poles, engaging the second hole position. Attach the Porch Velcro on each side of the Tent. The Tent is now ready to be “set” in the next step.
PAGE 6
- Step Five To “set” the tent, grasp the tent material at the rear of the shelter and pull it downward. Observe the porch area of the tent lifting accordingly as you pull. When the U-Channel Molding is correctly installed, the Porch Hoop Pole will lightly touch the floor. To achieve this condition, start by finding the center of the Molding. From behind the unit, pull the midpoint of the Tent downward and fold the Tent material under the lip of the Base.
PAGE 7
- Tips for Use Folding and transporting your Fish Trap is easy: ŀ Push the spring buttons and retract each hoop, starting with the rear hoop and working towards the front. Rotate all retracted hoops to the resting position. Tuck the tent into the base and between the hoops so that no material is left hanging on the ground for transport. ŀ Cover with the Travel Cover* (an optional but recommended accessory to help prolong the life of the unit).
PAGE 8