User's Guide

DOC ID - 1563 • Rev 09 3 / 17
Figure 2: Mechanical versus digital doorbell
Wi-Fi signal strength requirements
The Clare Video Doorbell must be connected to a 2.4GHz network and requires
a minimum -60dBm Wi-Fi signal strength at the installation location.
We recommend downloading a Wi-Fi analysis tool for your phone or tablet to
check signal strength. Stand at the doorbell installation location and test the Wi-
Fi strength. If a -60dBM signal or better is not achievable, we recommend
installation of a Wi-Fi range extender or Wireless Access Point (WAP) to ensure
proper video and audio streaming.
For a list of recommended Wi-Fi signal strength apps and tools, see Clare Video
Doorbell: Wi-Fi Signal Strength Apps and Tools Tech Bulletin (DOC ID 1608 Rev
02).
Installation
Before starting installation, make sure to shut off the doorbell’s power supply at
the breaker panel.
To install the Clare Video Doorbell:
1. Remove the existing doorbell and disconnect the wires connected to the
screws on the back.
2. Remove the Clare Video Doorbell’s faceplate by firmly holding the doorbell
and gently pressing down on the doorbell button and edge of the camera lens
bare.