User's Manual

IDSmart UHF Security Gate User Manual

1.4.2. Connecting and Holding the Panels Together

Get the slot fitting part and snap one side to the secondary panel and the other side to the

main panel as illustrated below. The cables (not seen in the diagram below) should remain on

top of the mounting plate. By snapping both the mounting plate with the slot fitting, the main and

secondary panel are hold together and stand firmly on the floor.

1.4.3. Arranging and Wiring the Cables

After securing the panels on the floor, put the RF cables and signal cables on the slot.

Place RF cables together away from the signal cable. Connect the RF cables and the signal

cable by plugging the male plug to the female jack. Make sure that the RF cables are tightly

secured.