User's Manual

IDSmart UHF Security Gate User Manual

The RF cables are labeled with Channel "A" to "D", be sure that cable with the same

channel labeled are connected together. The signal connector is a fool-proof connector.

1.4.4. Covering Up the Slot Fitting

When the wiring is done, take the cover and slide it into the top area of the slot. The left

end of the cover has a small opening that allow Ethernet cable and power cable to go through.

In standard installation, power and Ethernet cable are within the equipment itself.

1.4.5 Switching On the Equipment

Ensure that proper power (115VAC for Model J, 230VAC for Model A & C) is supplied to

the equipment by plugging the power cable to the socket. The on/off switch is underneath the

lamp shade of the main panel to prevent tampering. Use a thin rod to push the switch to turn on

the power. When the equipment is ready, the blue LED light bar on top of the gate will be lit.