User's Manual

IDSmart UHF Security Gate User Manual

3.6. UHF RFID Reader

The 16-port UHF RFID reader is conformed to EPC UHF Class 1 Gen 2 and capable of

supporting ISO18000-6C protocol. It is connected to the Ethernet interface of the embedded

board. The reader and the embedded board each has a fixed IP address assigned ensuring

direct communication between these two units..

Setting Value

Embedded Board Ethernet Port IP 192.168.25.210

Embedded Board Network Mask 255.255.255.0

UHF RFID Reader IP 192.168.25.203

UHF RFID Reader Network Mask 255.255.255.0

Note: User should not change the default IP address of the UHF RFID Reader.

Besides the internal Ethernet interface that connected to the Embedded Board. The

equipment also includes an external Ethernet Port (i.e. The Reader Setup Port) for

accessing the reader externally. This is particularly useful when user wish to calibrate

and tune the equipment for tag detection.

4. Modifying the Default Network Configuration

The security gate's network configuration (i.e. the configuration of LAN communication port)

can be changed by accessing the equipment through remote access terminal. SSH protocol is

selected for better security. This LAN communication port is the only port that user may change

according to the deployed networking environment.

4.1. Initial Network Configuration of UHF Security Gate

The factory default network configuration of the UHF Security Gate is as follows.

IP Address 192.168.10.210