User's Manual

IDSmart UHF Security Gate User Manual

This equipment's UHF RFID reader is capable of controlling 16 antenna ports. Only 8

antenna ports (Port 8 to 15) are attached to antenna for this equipment. The tool automatically

enables port 8 to 15 and disables port 0 to 7 when "Antenna Config" is executed for the first

time. Users may configure the Dwell time, Inventory Cycle and Power Level of each antenna

port. Click "Apply" button to apply setting to a single antenna port. Click "Apply All" to apply

setting to all antenna ports according to what configured on the screen. The Antenna can be

switched on and off by clicking the corresponding radio button. The following configuration will

allow the equipment to scan through 8 antennas in 2 seconds as the dwell time for each

antenna port is 250ms.

Further adjustment can be done. The tool is handy for experimenting with different setting

of the equipment. Check the result of the setting by doing an inventory cycle.

6.4. Performing Inventory Operation

After setting up the desired value for the reader and antenna ports, users can then check

the result by performing inventory operation through the tool. Start the inventory operation by

selecting "Start" under the "Inventory" sub menu.