Owner's Manual
WOOFER FEATURES TWEETER FEATURES
CROSSOVER FEATURES
• UV protected vacuum
polypropylene cone bodies
with synthetic rubber
surrounds, specifically
formulated for marine
duty
• High-efficiency design with
neodymium motor system
• Natural woofer roll-off with 2nd
order high-pass filter
on
tweeter
• 0.5-inch
(13
mm)
PEI
diaphragm
with specially formulated
treatment
to
withstand UV
• Crossovers are integrated into
woofer basket, requiring
no
additional mounting provision
• Marine-grade, synthetic spider
and
salt-spray exposure
• Wide mounting flange
design maximizes retrofit
compatibility with standard
6.5-inch marine speakers
• Permanent, basket-mounted
design ensures optimal high-
frequency performance with no
loss
of
woofer radiating area
• Meets salt-fog and UV exposure
standards
(AST
M B117/O4329)
Included Components and Parts:
• Two Marine Coaxial Loudspeakers
• Two White Sport Speaker Grilles
• Two Black Sport Speaker Grilles
• Two 2nd Order High-Pass Filters
(integrated within woofer baskets)
• Two 0.250-inch Female Crimpable Connectors
• Two 0.187-inch Female Crimpable Connectors
• Twelve
M4
x
30
mm
Stainless-Steel Mounting Screws
• Mounting Template
• Owner's Manual
BEFORE
YOU
BEGIN INSTALLING
• Check with your local waterway authority
for any regulations regarding the use
of
accent/speaker lighting
on
your vessel.
• Turn
off
the
audio system. It is also
advisable
to
disconnect your battery system
whenever performing installation work.
• Before cutting, drilling
or
inserting any screw,
check
clearances
on
both sides
of
the planned
mounting surface. Also
check
for any potential
obstacles, such as wiring harnesses, fuel
lines, hydraulic lines, etc. Check both sides
of
the vessel before cutting any holes.
• If you are running cables through bulkheads,
drill holes for the cable and use a urethane
or
plastic
grommet
to
protect the wire from
chafing in the hole. Make sure that the
cables will clear any mechanical devices in
the
boat and secure them with wire ties.
• Wear protective eyewear at all times and a
dust
mask and gloves when drilling
or
cutting.
mcAUTIONI
When installing speakers in your vessel, it is
extremely important
to
secure them firmly. This
applies not only
to
the speakers themselves,
but
also any structure they are mounted to. If not firmly
attached, the speakers can become dangerous
projectiles in a collision. Please review the
mounting information carefully
and
use the supplied
marine-grade hardware
to
mount this product.
mwARNINGI
While
these
speakers
are
designed to
be
water
and
spray
resistant,
they
are
not designed to
be
submerged
or to
withstand high-
pressure
water
spray.
Do
not
install
on
submersibles,
personal
watercraft or
any
other
vessel
likely
to
be
under water at
any
time.
Please
exercise
care
when
washing
your boat to
avoid
damaging your
speaker.
Avoid
contact with
harsh
chemicals
or
cleaning
agents
to prevent
damage
to the
speaker's
finish
that will not
be
covered
under
warranty.
Wash
with mild
soap
and
rinse
with
freshwater
only.
mcAUTIONI
Prolonged exposure
to
sound pressure levels in
excess
of
1
00dB
can cause permanent hearing
loss. This high-performance speaker can exceed
this level. Please exercise restraint
in
its operation
in order
to
preserve your ability
to
enjoy its fidelity.
mwARNINGI
It is absolutely vital that your coaxial speaker
system is connected as shown
in
this manual.
Failure
to
connect
the
system as shown will
result in damage
to
your speakers which
is NOT covered under warranty. Do
not
substitute different crossover networks.