Owner's Manual

CC510 3
English
Owner’s Manual
• Thisdevicehasbeendesigned
exclusively for use with a vehicular
mounted rear-view system. It should
 notbeusedforotherpurposes.
• Disconnectthevehicle’snegative(–)
terminal when installing wiring.
• Donotattempttodisassembleor
modify this product.
• Intheeventitisnecessarytodrill
holes in the vehicle for mounting,
 confirmthatthedrillbitorcamera
wiring will not strike or interfere with
piping, gas tank, electrical wiring or
other functional parts of the vehicle.
• Donotrelysolelyonthemonitor
image when reversing the vehicle.
 Therear-viewmonitorisanauxiliary
 devicemeantforconfirmingthe
 presenceofobstaclestotherearof
 thevehicle,andislimitedinitsrange.
 Itshouldbeusedonlyinconjunction
 withdirectvisualobservations.
• Alwaysreverseatlowspeeds.
 Therear-viewmonitorproducesawide
 angleimage,withtheresultthat
 actualdistancesmaybedifferentthan
 theysubjectivelyappearinthemonitor.
• Donotusewhentheimagingsurface
or other parts are malfunctioning.
• Wheninstallationandwiringare
completed, confirm that the vehicle’s
 horn,brakeandwarninglights,and
other electrical equipment function
properly as designed.
• Installonlyasdirectedinthe
Installation Manual.
• Installaccessorypartsasdirected.
• Whendrillingholesinthevehiclefor
installation of wiring, always use
insulated grommets in the holes to
protect the wiring.
• Ifholesaredrilledinthevehicleto
install the camera, or when installing
wiring, use silicon sealant to seal any
gaps.
• Donotdamageorscarthecamera
wiring.
• Aftercompletingthecamerawiring,
 usecableclampsorinsulationtape
 tobundlethewiringtogether.
• Theimagesproducedfromtherear-
view monitor are inverted right-left
in the same way as images seen
in the vehicle’s rearview mirrors. The
image may differ depending on the
vehicle type.
• Donotusehigh-pressurecar
washing devices around the camera.
 Thecameraisahigh-precision
 instrumentandshouldnotbesubjected
 tohigh-pressurewaterstreamimpacts.
•Periodicallycheckthetightnessof
the installation screws and retighten
if necessary.
WARNING
CAUTION
Powersource/voltage: DC12.0V(10.8~15.6V)
Powerconsumption: Max:100mA(±20mA)
Imagesensor: 1/4”ColorCMOSsensor
Angleofview: 150degrees(horizontal),90degrees(vertical)
Minimumsubjectillumination: 0.5lux(at50IRE)
IngressProtection: IP67
SNratio: 36dB(AGCON)orbetter
Weight: 0.423ounces(0.0265pounds)
Dimensions: 23(W)x23(H)x22(D)mm
Note:Specificationsanddesignaresubjecttochangewithoutnotice
forfurtherimprovement.
3. SPECIFICATIONS