Owner's Manual

CC510 5
English
Owner’s Manual
Before installation
• Beforeinstallingthecameraorits
 wiring,readallsafetywarningsandbe
 suretoinstalltheunitcorrectly.
• Beforeinstallingthecamera 
 permanently,useadhesivetapeto
 mountthecamerainitsproposed
 position,thenchecktheimageinthe
 monitortoconfirmproperdisplay
 beforefixingthecamerainitsfinal
position.
•Disconnectthebattery’snegative(–)
terminal installing wiring.
Precautions when using
two-sided tape for installation
• Asfaraspossible,installonaday
 withclearweather.
• Withinthefirst24hoursafter 
 installation,donotexposethe 
 installationtomoisture(water,rain,
 mist,snow,etc.),orsubject 
 theinstallationtostrongforcesor
 impacts.
• Wheninstallationmustbeperformed
 underconditionsoflowambient
 temperature(20°Corbelow),usea
 hairdryertowarmthesurfaceofthe
 bracketwherethe2-sidedtapeistobe
 applied.
• Donottouchthebracket-mounting
 surface’s2-sidedtape,anddonot
 attempttomoveorresetthetapeafter
initial application.
Notes:
• Before removing the protective paper
on the bracket, place it in the proposed
position on the vehicle and confirm
that the surfaces match properly
without gaps.
• When using screws to install the
bracket, use the right-left screw holes
provided on bracket A.
Donotinstallonglassorbody
surfaces treated with fluorinated
resins or other water-repellent
treatments.
Do not install within the sweep of
a rear window wiper, or near the
window washer’s nozzle.
Abidebythefollowingrulesinorder
to prevent lowering of the installation
tape’s adhesion:
5. INSTALLATION
WARNING