Product Manual

English

Owner’s Manual

CM1624TB / CM1624TS

4. INSTALLATION

STEP 1:

Remove tower speakers and all the hardware

from the packaging.

STEP 2:

Using supplied M4 Allen wrench, loosen the

base clamp hex head shaft bolts on the left and

right side.

STEP 3:

Begin by pulling mount assembly out of base

clamp while feeding the cable through the mount

hole to create a gap between base and surface

mount parts.

STEP 4:

When adequate space is created, use the su-

pplied M5 Allen wrench to loosen and remove

the bolts connecting the surface mount and bar

mount pieces.

STEP 5:

Once the bolts are removed, pull the bar mount

and assembly completely off of the wire.

STEP 6:

Find a good location to run the wires that will not

impede movement of the tower speakers.

NOTE:

The tower speaker accommodates two different

types of speaker wire installation:

1. Going straight into a hole in the surface thus

the speaker wire will be routed through the cen-

ter hole of the rubber spacing insert. For this ins-

tallation type, please proceed to STEP 7.

2. Alongside the surface thus the speaker wire

will exit the rubber spacing insert through the

side notch. For this installation type, please pro-

ceed to STEP 8.

NOTE:

Blue Loctite is highly recommended when

installing the hex head bolts.

Surface Mount Installation

M4 Allen

Wrench

M5 Allen

Wrench