CMRCI-BSS CMRSI-SB MARINE REMOTE-MOUNTED CONTROL PANEL Owner's Manual / Installation Guide www.clarion.com Customer Service 800.347.8667 POWER ����� SOURCE ������ ��� VOL 2005 Clarion Corporation All rights reserved. This material may not be reproduced or copied, in whole or in part, without the written permission of Clarion Corporation.
LIMITED WARRANTY INFORMATION For USA and Canada only This product is warranted against all defects in material workmanship for a period of one year from the date of original purchase. Clarion ProAudio products, except for speakers, are covered by a two year limited warranty when installed by an authorized Clarion dealer. The conditions of this limited warranty and the extent of responsibility of Clarion Corporation of America (“Clarion”) under this limited warranty are as follows: 1.
2. Connecting the illumination lead. The illumination circuit of the CMRCI-BSS/SB operates with a +12V input. Wire with a .250 female insulated spade terminal (not supplied), and connect the illumination terminal on the rear of the panel to a 0.5A in-line fuse (not supplied). Connect the other side of the fuse to an illumination circuit boat. Precautions 3. Connecting the cables. Connect the DIN cable from the CMD4 or M455 AM/FM/CD to the remote(s). Route it carefully to avoid moving parts.
1. INTRODUTION 2. CLEAN AND MANTAINANCE The CMRCI-BSS/SB is a waterproof remote control paneL which allows operation of the Clarion CMD4 or M455 head unit from a remote location. The CMD4 or M455 unit is an AM/ FM CD player with controls for an optional CD changer and an optional Sirius Satellite Radio receiver. Clean the remote control panel with a slightly damp, soft cloth using household glass cleaner. Do not use solvents such as benzene, thinner, or commercially available cleaners.
1. 2. Determine the mounting location is a flat surface with sufficient rear clearance (2.5”) and access. Ensure that the installation can be successfully completed before continuing! If the cable is not long enough, a 24ʼ extension is available - P/N M101RXC. USING THE REMOTE CONTROL PANEL The remote control panel requires a 2” (51mm) diameter round hole. Cut the hole and insert the remote control panel as shown. Break Lines 3” (mm) Diameter Hole 4.
The [MUTE/PLAY/PAUSE] button: The [SELECT UP/DOWN] buttons: ���� In the Radio mode: this buttom mutes the system. press the buttom again to defeat the mute feature. In Radio mode: these buttons select the next preset radio station in the memory. In the CD mode: this bottom pauses playback of the CD. To resume playback, press this buttom again.