User's Manual

English
19
CX505
6-Spacer (thickness: 1 mm)
8-Hexagonal screw (M5 × 6)
Center Panel *1
Screws marked
and mounting bracket are attached to the vehicle.
NISSAN
TOYOTA
6-Flat head screw (M5 × 6)
(attached to the main unit)
Mounting bracket
(1 pair for the left and right sides)
Mounting bracket
(1 pair for the left and right sides)
*2
NISSAN TOYOTA
Example 1-3
Cautions On Wiring
• Be sure to turn the power off before wiring. Be particularly careful where you route the wires.
• Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
• If the fuse should blow, check to see if the wiring is correct. If a fuse is blown, replace it with
anew one of the same specication as the original.
• To replace the fuse, remove the old fuse of the power supply cord and insert the new one.
Note:
• There are various types of fuse holder. Do not let the battery side touch other metal parts.
• After the connection, x the cord by a clamp or insulation tape for protection.
Mounting Screw Holes (Side View of the Main Unit) Note:
*1 Some panel openings are too small for the unit depending on the vehicle type and model.
In such a case, trim the upper and lower sides of the panel frame by about 0.5 to 1.5 mm so
the unit can be inserted smoothly.
*2 If a hook on the installation bracket interferes with the unit, bend and atten it with a nipper
or similar tool.
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modication. (Trimming, lling, etc.)
Typical Mounting Brackets
In some cases the center panel may require modication. (Trimming, lling, etc.)
Afx the screws to the marks.
Fuse (15A FUSE)
Fuse holder