Specifications

142
UNGO – Programming Guide
RS10 (Remote Start with Keyless Entry)
Feature Default LED ON LED OFF Setting
Number (Press Channel 1) (Press Channel 2)
1 Engine Check ON Engine Checking OFF
2 Tachometer Sensing Voltage Sensing
3 12 Minute Run Time (1)* 24 Min (2)*, 60 Min Run Time (3)*
4 Flashing Parking Light Output Constant Parking Light Output
5 Cranking Time 0.6 Sec. (1)* Crank Time 0.8 (2)*, 1.0 (3)*, 1.2 (4)*, 1.4 (5)*,
1.6 (6)*, 1.8 (7)*, 2.0 (8)*, 4.0 (9)*
6 Voltage Check Level High Voltage Check Level Low
7 Short Run (Turbo Timer): 1 Min. (1)* Short Run (Turbo Timer): 3 (2)*, 5 (3)*, 10 (4)*
8 Activation Pulse: 1 (1)* Activation Pulses: 2 (2)*, 3 (3)*
9 Ignition/Accessory Output: Ignition Ignition/Accessory Output: Accessory
10 Accessory State During Wait to Start: OFF Accessory State During Wait to Start: ON
11 2nd Status Output: Normal (1)* Rear Defogger Latched (2)*, Pulsed (3)*
12 Diesel Time Wait-to-Start Input (1)* Timed 15 (2)*, 30 (3)*, 45 (4)* Seconds
13 Run Time (Timer Mode) 12 Minutes (1)* 3 (2)*, 6 (3)*, 9 (4)* Minutes
14 Door Lock Pulse Duration 0.8 Sec. (1)* 3.5 (2)*, 0.4 (3)* Seconds
15 Unlock Output 1 Pulse Unlock Output 2 Pulses
16 Lock Output 1 Pulse Lock Output 2 Pulses
17 Ignition Unlock ON Ignition Unlock OFF
18 Ignition Lock ON Ignition Lock ON
19 Factory Alarm Disarm Function with Unlock Before Lock (2)*, Remote Start Only (3)*
20 Factory Alarm Disarm 1 Pulse 2 Pulse
21 Comfort Closure ON OFF
Note: Factory default settings are shown BOLD.
Note: * The number in parentheses indicate the number of times the LED will flash.