Owner`s manual

Basic Operations
Sound Adjustment
You can adjust a sound effect or tone quality to
your preference.
To change sound setting
1. Press the [SOUND] button to switch to the
sound adjustment selection display.
*The factory default sound setting is "Z-
EHCR+".
2. Then press the [~] or [~] button to
select the sound adjustment mode.
Each time you press the
[~] or [~]
button, the sound adjustment mode
changes as following order:
"Z-EHCR+"
<---+ "BASS" <---+ "TREBLE" <---+
"BALANCE" <---+ "FADER" ~ "NF VOL"
* In the case of display blinking "ENT", you
can press the [~~~] button to adjust the
setting value.
* The sound adjustment mode will be
displayed for 2 seconds before showing the
sound setting.
3. Turn the [ROTARY] knob to adjust the
selected audio mode.
4. After completing settings, press the
[SOUND] button to return to the previous
mode.
• Setting the Z-Enhancer Plus
This unit is provided with 4 types of sound tone
effects stored
in memory.
Select the one you prefer.
* The factory default setting is "OFF".
2-1. Select "Z-EHCR+".
3-1. Each time you turn the [ROTARY] knob,
the tone effect changes
in the follOWing
order:
"OFF"
~ "B-BOOST' <---+ "IMPACT' <---+
"EXCITE" <---+ "CUSTOM"
OFF : no sound effect
B-BOOST : bass emphasized
IMPACT : bass and treble emphasized
EXCITE : bass and treble emphasized
mid emphasized
CUSTOM : user custom
14 DB185MP
When "B-BOOST/IMPACT/EXCITE" is set:
3-2. Press the
[~NI~] button.
3-3. Turn the [ROTARY] knob to adjust the
setting
in the range of -3 to +3.
* The factory default setting is "0".
3-4. Press the [~~~] button to return to the
previous mode.
When "CUSTOM" is set:
3-2. Press and hold the
[~~~ ] button for 1
second or longer. Bass/treble
characteristics become flat and "FLAT" is
show
in the display.
3-3. Turn the [ROTARY] knob to change to the
"OFF" mode.
• Adjusting the bass
This adjustment can be performed only when
the Z-Enhancer Plus is set to "CUSTOM
".
2-1. Select "BASS".
3-1. Press the
[~~n button.
3-2. Press the [ .... ~] or [~] button to select as
following order.
"B<G 0>"
<---+ "B<F 60>" <---+ "Q 1"
3-3. Turn the [ROTARY] knob to adjust the
gain, the F (center frequency) and the
Q.
B<G 0> :The factory default setting is "0".
(Adjustment range:
+7 to -7)
B<F 60> :The factory default setting is
"60".
(Adjustment range: 60/80/100/
200)
Q 1 :The factory default setting
is "1".
(Adjustment range: 1/1.25/1.5/2)
3-4. Press the
[~NI~ ] button to return to the
previous mode.