.. ..--.... --.. .... ..--.... -..--...... ...... ..-...... ...... .. .. .. ..- - - .. ..-.. ..- .. -.. .. -.. .. .. .. .. .. -..
DPX1000.2 Power System Amplifier INTRODUCTION INTRODUCTION The Clarion DPX1000.2 is a full-featured two-channel amplifier that. incorporates the following features: 2 • Digital Technology for high efficiency and high power output.
OWNER'S MANUAL TABLE OF CONTENTS Description • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • Input Connections and Audio Controls • • • • • • • • • • • • • • • • • • • • Connections for Power and Speakers • • • • • • • • • • • • • • • • • • • • • Applications • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • Installation • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • Mounting Precautions • • • • • • • • • • • • • • • • • • • • •
DPX1000.2 Power System Amplifier INPUT CONNECTIONS AND AUDIO CONTROLS The front panel of the DPX1000.2 contains connections for RCA Inputs, Speaker Level Inputs and Audio Controls as shown below. The RCA Input Connections are gold-plated RCA Jacks and are labeled as RIGHT and LEFT.
OWNER'S MANUAL this feature, along with your speaker manufacturer’s recommended crossover frequencies, to quickly design a more advanced system • X-Over Slope Switch - This switch will change the X-Over between a 12db and 24dB per octave slope. The steep crossover slope keeps midrange tones out of the subwoofer and thereby eliminates an unnatural “nasal” tone quality in the audio system. • Output Mode Switch - This switch is to change the output between lowpass and fullrange.
DPX1000.2 Power System Amplifier APPLICATIONS The Clarion DPX1000.2 2-channel car audio amplifier can be used in a variety of system applications. Here are some examples to help plan your own installation. APPLICATIONS Bridged- Mono Subwoofer System Set X-Over Mode to Lowpass and adjust FREQ to speaker specifications. Figure 3 - In this application the amplifier is bridged for mono operation to drive a subwoofer. Minimum load in the bridged mode is 2 ohms.
OWNER'S MANUAL 2-Channel Full-Range, Satellite, or Subwoofer Stereo System Set Ampz Mode as shown. L Full Range R Full Range Set Amp Mode as shown; adjust FREQ to speaker specifications. L Satellite R Satellite 2-way Passive Crossover 2-way Passive Crossover Set Amp Mode as shown; adjust FREQ to speaker specifications. L Subwoofer R Subwoofer APPLICATIONS Figure 4 - In this application, the amplifier is used in stereo and drives two full-range (or satellite or subwoofer) speakers.
DPX1000.2 Power System Amplifier (Set INPUT SELECT Switch to STEREO) Mixed-Mode Satellite and Subwoofer System L Speaker R Speaker + C C - + - + - APPLICATIONS L Subwoofer 4 ohms FREQ (hz) L (mH) C (uF) 80 100 125 150 200 8.0 6.4 5.1 4.2 3.2 497 398 318 265 199 Set amp mode switch to fullrange. NOTE: Chart values based on 4 ohm speakers. Figure 5 - The amplifier can be configured for a mixed-mode operation.
OWNER'S MANUAL INSTALLATION This section lists Mounting and Wiring Precautions for installing the Clarion DPX1000.2. These safeguards provide enough detail to successfully complete an installation. If you do not have the necessary skills, Clarion recommends consulting your authorized Clarion dealer for installation. MOUNTING PRECAUTIONS Although the Clarion DPX1000.
DPX1000.2 Power System Amplifier 5. Add an external fuse on the amplifier’s positive (+) power lead and connect it as close as possible to the vehicle’s (+) battery terminal. Use a rating that equals the total current consumption at full output of all amplifier in the system. Adding an external fuse will protect the electrical system from short circuits that can cause a fire. 6. Refer to Figure 6 when making electrical connections.
OWNER'S MANUAL Remote Turn-on F U S E + - BATTERY Chasis Groung (Bare Metal) Right Speaker + Right Speaker - Left Speaker + WIRING Left Speaker - Figure 6. - Electrical connections for the DPX1000.
DPX1000.2 Power System Amplifier SETTING THE GAIN After completing the installation, follow these steps to set the Gain Control and then perform the Final System Checks. 1. Turn the Gain Control all the way counter-clockwise. 2. Turn the vehicle’s Ignition Switch to the ON position. Then turn the ON/OFF Switch on the source units to the ON position. Set all Tone or Equalization Controls to “flat” positions and turn Loudness off.
OWNER'S MANUAL FINAL SYSTEM CHECKS 1. Start the engine and turn on the source unit. After a two-second delay, slowly increase the Volume Control and listen to the audio. If you hear any noise, static, distortion or no sound at all, check the connections, and also refer to Troubleshooting. Depending on your system design, the levels may become quite loud even at low Volume Control settings. Until you get an “audio feel” of the system’s power, use care when adjusting controls. 2.
DPX1000.2 Power System Amplifier Problem Audio lacks punch. Solution Speakers wired incorrectly, which causes cancellation of bass frequencies. Check polarity of wires from amplifier to each speaker as defined by the system design. Problem Amplifier fuse keeps blowing. Solution Incorrect wiring or short circuit. Review Installation and check all wiring connections. Problem Whining or ticking noise in the audio with engine on. Solution Amplifier is picking up alternator noise or radiated noise.
OWNER'S MANUAL NOTES NOTES 15
661 W. Redondo Beach Blvd. Gardena, CA 90247 1-800-GO-CLARION www.clarion-usa.com DPX1000.2-10 Rev.
Clarion clarion” CAR AUDIO AUBIO () 0 BEYOND BEYOND Produut Product Registration Registration for for USA USAand and Canada Canadaonly only IMPORTANT: IMPORTANT: Detachthis this section section of the the card card and and keep keep it with your records. 1. Detach records. 2. Retain Retainyour your sales sales receipt receipt to validate validate warranty 2. warranty service. service. 3. IfIf you you purchased purchaseda Clarion ClarionADX ADXSeries, Series, Pro ProVideo 3.
clarion WAR RAN T Y I N FOR MAT ION TEAR THIS THIS PAGE OFF AND KEEP IT WITH WITH YOUR RECEIPT! RECEIPT! TiAR I rlllllllllllllllllll L-T-l-l-I-I-Ii-l '. I', . • I . j • I-I • ,. I I I I I.' . mmm I " I , I I I I I I I I I I I I I. This This product product is is warranted warranted against against all defects defects in in material material workmanship workmanship for a period period of one one year year from from the the date date of original original purchase.
mmmi!PRODUCT PRODUCT REGISTRATION REGISTRATION CAR D CARD Thank selecting a high-quality high-quality product product from Clarion. Clarion. We We hope hope you you are completely completely satisfied satisfied Thankyou you for selecting with We'd like like to help help serve serve you you better better by finding finding out more more about about your reasons reasons for for with your your purchase. purchase.
II What is your age? (Optional) o:J g M_a_r_ita_I_S_ta_tu_s_?_~_OP_tl_'on_a_I) __22_D M_ar_rie_d__3_0_SI_'n . ..
III Which the following following products/services products/services do you you own own or intend intend to buy bUy within the next 18 months? months? Whichof the Intend to to buy buy Own O&W Intend - .,'" '" .
III IIIIII clarion Clariofl CAR AlllllN AUDIO 09 CAR BEYOND BEYNHD ~------~ PLEASE PLACE.. ~ FI1'1ST -CLASS STAMP HERE (Post Office will not deliver without proper postage) L~ CLARION CORPORATION CLARION SALES CORPORATION PO BOX 863 863 BREA BREA CA 92822-0863 92822-0863 11.1 •••• 1.11 •• 1••• 1.1 .. 1.111 ... 1•• 1.•11 .... 11 .. 11 ....11 ....
