User Guide

14 DVH920
280-7805-00
How to Wire This Unit
CAUTION
Throughout the process of wiring this unit,
disconnect the negative (–) terminal of your
automobile’s battery, and leave it discon-
nected until completely finished. Handling
wires while the terminal is connected could
result in dangerous electrical shock or injury
if an accidental short circuit should occur.
Perform the settings and
connections in the order
indicated by the drawing
below.
CeNET connector
CeNET cable
Sliding cap
Optical Digital cable
(black connection)
Cable clip
1 CeNET Cable
• To connect a CeNET cable, hold it with the
connector facing as shown, and insert se-
curely.
• When disconnecting a CeNET cable, grasp
the slide cap and squeeze gently.
2 Optical Digital Cable (sold separately)
• Insert the black connector securely into the
digital signal input connector until it locks.
The cable clip can be used to secure up to
two optical digital cables.
• When disconnecting a optical digital cable,
squeeze the tabs at the right and left sides
of the connector, and pull gently.
Note:
• The optical digital cable should not be bent
with a gentle arc radius of 1.5 cm or less. If it
is bent sharper than this, the performance of
the cable will be greatly reduced and the cable
may be damaged.
3 RCA Pin Cable (sold separately)
• When connecting an RCA pin cable, be sure
to confirm the source of the connection first.
4 [RESET] switch
• Following completion of wiring, press the
[RESET] switch to return to default settings.
Note:
• Always turn the main [POWER] switch [OFF]
before connecting or disconnecting digital fiber-
optic cables.
Note:
• Route the CeNET cable with plenty of extra
room so that the connector will not become
disconnected accidentally.
Squeeze
right/left tabs
280-7805-00_09-20 (En) 2/21/02, 4:13 PM14