User Guide

280-7805-00
DVH920 13
8. WIRING TECHNIQUES
Name of Parts
SLAVE
STAND
ALONE
1 CeNET connectors
Connect to center unit using CeNET cable.
2 Front RCA output connectors.
Connect to external power amplifier using
RCA pin cable.
3 Rear RCA output connectors
Connect to external power amplifier using
RCA pin cable.
4 Sub-woofer RCA output connectors
Connect to external power amplifier using
RCA pin cable.
5 Center speaker RCA output connectors
Connect to external power amplifier using
RCA pin cable.
6 Digital input connector
Connect to DVD/CD changer using optical
digital cable (sold separately or included).
* Connect to black connector side
7 Cable clip hole.
Insert cable clip to hold optical digital cable in
place.
8 RESET switch
Press to reset circuitry if no sound is pro-
duced.
Note:
• Be sure the CeNET cable is connected when
pressing the [RESET] switch.
Use When Connecting Optional
Control Unit (DVC920)
9 [STAND-ALONE / SLAVE] switch
• Set to STAND ALONE when connecting
a control unit.
• Leave at SLAVE position when no con-
trol unit is connected.
0 Analog input connectors (RCA)
Connect to center unit’s RCA 2ch output.
Note:
• The following are enabled only when a con-
trol unit is connected.
! Control unit 8P mini DIN plug
Connect to control unit.
@ Control unit power connector
Connect control unit’s power cable here.
* Leave tape in place when not in use.
[STAND-ALONE/SLAVE] switch
* The factory default setting is SLAVE
position.
280-7805-00_09-20 (En) 2/21/02, 4:13 PM13