INTRODUCTION The Clarion EQS560 is a full-featured five-band stereo equalizer specifically designed for the mobile environment.
1. Sub Level 2. Volume Control 3. Aux Switch 4. Fader Control 5. Sub Frequency Adjustment 6. Low Frequency Adjustment 7. Mid Frequency Adjustment 8. Mid-High Frequency Adjustment 9. High Frequency Adjustment 10. Power Plug 11. Front Output 12. Rear Output 13. Radio Input 14. Aux Input 15. Sub Output 16. Aux Gain Controls 17. Low-Pass Freq. 60/90Hz CONTROL GLOSSARY • Volume Control - This is the master volume control for the system.
• Low-Pass Frequency Switch - This allows the subwoofer crossover frequency to be set at 60Hz or 90Hz. • Subwoofer Level Control - This is the volume control for the subwoofer. The subwoofer level control allows you to adjust the subwoofer volume at any time to match any listening preference. • Aux Gain Controls - These controls allow individual left and right input gain adjustment for the auxiliary input. APPLICATIONS The system diagram below will help you plan your own installation.
4. If the unit should become wet, turn off all power and ask your authorized Clarion dealer to clean or service the unit. WIRING PRECAUTIONS Read all wiring precautions. If you are not sure of the connections, contact your authorized Clarion dealer. 1. This unit operates on an automotive 12V negative ground power source and requires additional mobile audio components for proper operation. 2. Disconnect the negative (-) lead of the battery before making any power connections. 3.
SYSTEM SET-UP Setting System Volume After completing the system wiring, follow the steps below to properly adjust the EQS560. 1. Turn the master volume control on the EQS560 and the amplifier gain controls to their minimum setting. 2. Turn the source unit on and increase the volume until distortion is heard, then reduce volume just below this point.* Once the source unit volume has been set, it will no longer be used. Always use the volume control on the EQS560 as the master (main) volume control.
4. Adjust the auxiliary input gain controls, located on the top panel of the EQS560, so that the volume of the auxiliary source matches the volume of the main source. TROUBLESHOOTING Problem Unit does not work; no lights. Solution • Power wires are not connected. Check battery and ground wiring at unit; check battery connections. Problem Sound is distorted. Solution • Source unit volume is set too high. Reduce source unit volume. • EQ controls are set too high.
661 W. Redondo Beach Blvd. Gardena, CA 90247 1-800-GO-CLARION www.clarion-usa.com PEQ460-10 Rev.
