Owner`s manual

8. INSTALLATION I WIRE
CONNECTION GUIDE
CONTENTS
1) Before Starting 25
2) Package Contents 25
3) General Cautions 25
4) Cautions
on Installation 26
5) Installing the Source Unit 26
6) Removing the Source Unit 28
7) Wiring and Connections 29
8) Connecting the accessories 30
1) Before Starting
1. This set is exclusively for use in cars with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery "terminal" before
starting. This
is to prevent short circuits during
installation. (Figure
1)
Car battery
2) Package Contents
Figure 1
Source unit 1
Trim ring 1
Mounting bracket 1
Screws M5x6 mm 4
L-key 2
3) General Cautions
1. Do not open the case. There are no
user serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized
Clarion service center.
25 FZ501
Wire connector 1
Owner's manual. 1
Warranty card 1
Remote control (with battery) 1
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, or alcohol etc. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe off the dirt gently.