Owner`s manual

Basic Operations
Note:
• Refer to the diagrams in "3. CONTROLS"
when reading this chapter.
A CAUTION
When the unit is turned on, starting and
stopping the engine
with its volume
raised to the maximum level may harm
your hearings.
Be careful about adjusting the volume.
Power on / off
Notes:
• Start the engine before using this unit.
•
Be careful about using this unit for a long
time without running the engine. If you
drain the car's battery too far, you may not
be able to start the engine and this can
reduce the service life of the battery.
1. Start the engine. The power button / knob
illumination
on the unit will light up.
~ EngineON
\..?WJ position
2. Press the [CONTROL] knob on the front
panel or [SRC
I <!>] button on the remote
control to turn
on the power under standby
mode. The unit goes back to the last
status after power on.
3. Press and hold the [CONTROL] knob
(center long press) on the front panel,
and rotate the [CONTROL] knob choose
POWER OFF, then press the [CONTROL]
knob
on the front panel to turn off the
power.
Or press and hold [SRC
I <!>] button on
remote control to turn off the power.
Mute
Press the [MUTE] button on the remote
control to mute the volume from the unit.
Note:
Doing the operation above again or adjusting
volume will release muting.
Volume adjustment
Turn the [CONTROL] knob on the front
panel.
The adjustable range of volume is 0 to 40.
A CAUTION
While driving, keep the volume level at
which external
sounds can be heard.
Playing source selection
Press [CONTROL] knob on the front panel
repeatedly to choose desired playing source.
Notes:
• Playing source selection means selecting
work mode, such as RADIO mode and
AUX mode, etc.
Display system time
Press the [DISP] button on the remote
control to switch the display information,
system time and playing source.
RESET
Note:
* When the [RESET] button is pressed,
frequencies of radio stations, titles, etc.
stored
in memory are cleared.
RESET
FZ501 8