Owner`s manual

12
English
Satellite Radio Mode
Listeners can subscribe to SIRIUS
®
Radio on the
Web by visiting www.sirius.com, or by calling (888)
539-SIRIUS. Customers should have their SIRIUS
ID ready (SIRIUS ID is located on the SC-C1
SIRIUS Connect Vehicle Tuner, solid separately).
Customers can listen to music samples by tuning
to channel 184.
Accessing satellite radio mode
Press the [CONTROL] knob or [SRC / ]
button on the remote control to switch to the
SAT source.
Displaying the Identication (ID) Code
Before you listen to satellite radio, you must
subscribe to the service using your radio’s
identification number. To display the radio
ID, use the [CONTROL] knob (left) or [ ]
tuning button on the remote control to tune to
channel “0”. The screen displays the radio ID
where the channel name is usually displayed.
Check SC-C1 SIRIUS Connect
Vehicle Tuner
If SIRIUS tuner is not connected, “NO
TUNER” will appear on the LCD.
Select a band
Press the the [CONTROL] knob (up long
press) on the panel or [BAND/TOP] button
on the remote control to change between
three SAT bands (SR1, SR2 and SR3). Each
band stores up to six preset stations.
Select a station
Press the [CONTROL] knob (left / right) on
the panel or [ , ] buttons on the remote
control to tune to another station.
Preset mode
Six numbered preset buttons on the remote
control store and recall stations for each
band.
Preset scan
Short press the [SCN/PS/AS] button on the
remote control to start category scanning.
Long press the [SCN/PS/AS] button on
the remote control to start preset station
scanning for 10 seconds each.
Storing a station
1. Select a band (if needed), then select a
station.
2. Press and hold a preset button (numbers
1-6) on the remote control.
3. T he p reset nu mber and stati o n i s
displayed and highlighted.
Recalling a station
1. Select a band (if needed).
2. Press a remote control preset button
(numbers 1-6) to select the corresponding
stored station.
Category and Channel search
To access Category and Channel Search
mode, press the [CONTROL] knob (up long
press) on the panel or [BAND/TOP] button
on the remote control long press.
1. Rotate the rotary knob on the panel to
select the desired category.
2. Press the [CONTROL] knob (left / right)
on the panel or [ , ] buttons on the
remote control to select the channel name.
Direct search
To access Direct Search mode, press the
[CONTROL] knob button on the front panel.
1. Rotate the [CONTROL] knob on the panel
to select the desired direct, and press the
[CONTROL] knob to conrm the selection.
2. Rotate the [CONTROL] knob on the
panel or press the [ ] or [ ] button
on the remote control to select the direct
name, and press the knob to conrm the
selection.
PASSWORD
Refer to System Setup page 9.
LOCK
Refer to System Setup page 9.
UNLOCK
Refer to System Setup page 9.
UNSKIP
Refer to System Setup page 9.