User's Manual
Page 13/20
Clarion Confidential
(1) Configure the TCU
The below is the procedure to configure the TCU to establish the RF communication with the cellular tester.
1. Setup the evaluation environment according to chapter 4.1 and Appendix C.
2. Start the program ‘TCU Control Tool’.
3. Click the button A.
4. Select the COM port number in the B. COM port name is ‘USB Serial Port’. It can be found in the device manager on
windows PC.
5. Click the button
C. And wait until ‘ACTIVE’ is displayed on E.
6. Supply DC Power 13.5V(9V~16V) to the TCU.
7. Click the button
M. And wait to until ‘ACTIVE’ is displayed on N.
Note: It can take about 20seconds to show the result OK.
8. Click the button
O. And wait until ‘OK’ is displayed on P.
9. (i) In the case of communication with WCDMA signaling;
Click the button
Q. And wait until ‘OK’ is displayed on R.
(ii) In the case of communication with GSM signaling;
Click the button
S. And wait until ‘OK’ is displayed on T.
10. Click the button
D.
11. Power off the TCU.
12. Configuration of TCU is completed.
A
B
C
D
E F
G
H
I
N
P
Q R S T
U V W
Y
J K L
3
4
5
O
M
7
9
10
8