User Guide

Software Installation - (Initially for Dealers)
Congratulations on your purchase of the JoyRoute™ Plus Navigation software for Large
Display!
Caution: When installing the software, do not turn the ignition (ACC power) switch OFF. Also
avoid pressing any buttons, keys or reset buttons. Hardware failures may result.
Installing Navigation
1. Turn on vehicle ignition.
2. Insert the CD installation disc, JoyRoute Plus™ Navigation for Large Display into the in-dash
DVD drive.
3. At the “Install Navigation” screen press Enter. Joyride announces “the system is attempting
to install or run a program contained on the media inserted.” (If more than one installation
program exists, press to select “JoyRoute Navigation - Large Display.”)
4. Press key to select “Yes.”
5. Press key to select “No” to the question ”Perform Backup Now?” (Select “Cancel” to
abort the installation.)
A Please DO NOT INTERRUPT warning displays. Do not touch the faceplate or
control panel while the following message displays: “Preparing to Install...”
Speech Training for Safety
Read the instruction to “Say the command word 3 times after the prompt.” A series of
Navigation speech commands start to display. Press Enterto start.
6.Reset Required – The installation prompts you to press Enterto reset to complete the
installation.
xi