User Guide

xi
JoyRoute™ Navigation for
Software Installation - (Initially for Dealers)
Congratulations on your purchase of the JoyRoute™ Navigation software for Small Display!
Caution: When installing the software, do not turn the ignition (ACC power) switch OFF.
Also avoid pressing any buttons, keys or reset buttons. Hardware failures may result.
Installing Navigation
1. Turn on vehicle ignition.
2. Insert the CD installation disc, JoyRoute™ Navigation for Small Display into the in-dash
DVD drive.
3. At the “Install Navigation” screen press Enter. The Joyride™ system announces “the system
is attempting to install or run a program contained on the media inserted.” (If more than
one installation program exists, press to select “JoyRoute™ Navigation - Small Display.”)
4. Press key to select “Yes.”
5. Press key to select “No” to the question ”Perform Backup Now?” (Select “Cancel” to
abort the installation.)
A Please DO NOT INTERRUPT warning displays. Do not touch the faceplate or con-
trol panel while the following message displays: “Preparing to Install...”
Speech Training for Safety
Read the instruction to “Say the command word 3 times after the prompt.” A series of
Navigation speech commands start to display. Press Enterto start.
6.Reset Required – The installation prompts you to press Enterto reset to complete the
installation.