M301RC-RET MARINE REMOTE-MOUNTED CONTROL PANEL Owner's Manual / Installation Guide VOLUME SELECT VOLUME SELECT BAND DISC SOURCE POWER MUTE
Precautions Table of Contents Make certain that the remote is installed in a location which does not interfere with the safe and proper operation of the boat. 1. Introduction ..................................................................... 4 The M301RC-RET is only compatible with the XMD3-RET AM/ FM/CD Player. 3. Using the Remote Control Panel ................................... 5 Page 2. Care and Maintenance ................................................... 4 4. Installation and Wiring .....
1. INTRODUCTION The M301RC-RET is a waterproof remote control panel which allows operation of the Clarion XMD3-RET head unit from a remote location. The XMD3-RET unit is an AM/FM CD player with controls for an optional CD changer and an optional Sirius Satellite Radio receiver. A maximum of two M301RC-RET units may be used with a single XMD3-RET (using an optional M101RYC-RET adapter). The M301RC-RET can be connected to your boat’s illumination circuit, backlighting the panel in low-light condi tions.
3. USING THE REMOTE CONTROL PANEL The [POWER/SOURCE] button: SOURCE POWER Using the Remote Control Panel The M301RC-RET remote control allows the user to control the Clarion XMD3-RET AM/FM/CD Player from a remote location, even if the source unit is mounted out of sight in a compartment or in a different area. Display To turn the unit on, press this button momentarily. To turn the unit off, press and hold for 1 second.
The [MUTE] button: The [SELECT UP/DOWN] buttons: MUTE SELECT Pressing this button mutes the system audio in all modes. Press this button again to defeat the mute function. SELECT In Radio mode: these buttons select the next preset radio station in the memory. The [VOLUME UP/DOWN] buttons: VOLUME VOLUME These increase and decrease the system volume. If the [MUTE] function is active, pressing one of these buttons defeats the mute function.
4. INSTALLATION AND WIRING 1. Before Starting 3. Installing the Unit Selecting the Location Location of the panel varies. Read these instructions and the following precautions. Precautions • This unit is exclusively for boats with a negative ground, 12V power supply. • Do not open the case. There are no user-serviceable parts inside. If you require assistance, consult your Marine Audio dealer or an authorized Clarion service center.
1. Determine the mounting location is a flat surface with sufficient rear clearance (2.5”) and access. Ensure that the installation can be successfully completed before continuing! If the cable is not long enough, a 24’ extension is available - P/N M101RXC-RET. 2. The remote control panel requires a 2” (51mm) diameter round hole. Cut the hole and insert the remote control panel as shown. 3. The mounting bracket is scored with “break lines’ to allow use with panels of different thicknesses.
5. Position the bracket onto the rear of the remote control panel, sliding the two threaded studs on the rear of the panel through the two holes in the mounting bracket (as shown below). Tighten the 7mm hex nuts onto the bracket, again ensuring that the gasket seals tightly to the front of the mounting surface. Avoid pinching the cable. Wiring Connections Take the following precautions before wiring your system. • Disconnect the negative battery terminal before making any wiring connections.
2. Connecting the illumination lead. The illumination circuit of the M301RC-RET operates with a 12V(+) input. Wire with a .250 female insulated spade terminal (not supplied), and connect the illumination terminal on the rear of the panel to a 0.5A in-line fuse (not supplied). Connect the other side of the fuse to an illumination circuit of the boat. 3. Connecting the cables. Connect the DIN cable from the XMD3-RET AM/FM/CD to the remote(s). Route it carefully to avoid moving parts.
LIMITED WARRANTY INFORMATION For USA and Canada only This product is warranted against all defects in material workmanship for a period of one year from the date of original purchase. Clarion ProAudio products, except for speakers, are covered by a two year limited warranty when installed by an authorized Clarion dealer. The conditions of this limited warranty and the extent of responsibility of Clarion Corporation of America (“Clarion”) under this limited warranty are as follows: 1.
www.clarion.com Customer Service 800.347.8667 c 2003 Clarion Corporation All rights reserved. This material may not be reproduced or copied, in whole or in part, without the written permission of Clarion Corporation.