Owner`s manual
Setting
the Z-Enhancer Plus
This unit are provided with 3 types of sound tone
effects stored
in
memory. Select the one
you
prefer.
*The factory default setting is
"Z+
OFF".
Each time you press the [Z+] button, the tone
effect changes in the following order:
"Z+
OFF"
"B-BOOST"
"IMPACT" ...
"EXCITE" "CUSTOM"
"Z+
OFF" .
* Once selected, the preferred display becomes
the display default. When a function
adjustment such as volume is made, the
screen will momentarily switch to that
function's display, then revert back to the
preferred display several seconds after the
adjustment.
Main display
:::ir1
Clock display
~
Sub display (Satellite mode only)
CiR
'n
=,
4l,]
__
"
__
',
It_'
CH
••
' ,
~~
II"--,,r-
IIICIIII_J
Main display
SWitching the
display
Press the [DISP] button to select the desired
display.
Each time you press the
[DISP] button, the
display switches
in
the following order:
Adjusting
the volume
Turning the [ROTARY] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
* The volume level is from 0 (minimum) to 33
(maximum).
Note:Be sure to read this chapter referring
to
the front diagrams
of
chapter
"3.
CONTROLS" on page 5 (unfold).
Selecting a
mode
Press the [SRC] button to change the
operation mode.
2.
Each time you press the [SRC] button, the
operation mode changes
in
the following
order:
Radio
mode'"
Satellite
mode'"
CD
mode
... iPod
mode'"
CD changer
mode'"
TV
mode'"
AUX
mode'"
Radio
mode
...
* External equipment not connected with
CeNET is not displayed.
Basic Operations
Turning
on/off
the
power
Note:
• Be careful about using this unit for a long time
without running the engine.
If
you drain the boat's
battery too
far,
you
may
not be able to start the
engine,
and
this can reduce the service life
of
the
battery.
1.
Press the [SRC] button.
2.
The illumination and display on the unit light
up.
The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
Press and hold the
[SRC] button for 1
second or longer to turn off the power for the
unit.
Note:
• System check
During the initial
power
up
of
this unit,
it
will go
through a system check procedure. This
procedure verifies
any
devices connected through
GeNET.
Any
additional GeNET devices plugged
into the unit after the initial
power
up will initiate
the system check procedure. The system check
starts automatically within the unit.
Lower the volume level before powering the
source unit off. The
source
unit
stores
the
last
volume
setting.
If
the
source
unit
is
powered
off
with
the
volume
up, when
the
source
unit
is
powered
back
on,
the
sudden
loud
volume
may
harm
your
hearing
and/or
damage
the
source
unit.
M455A
15