Model RK1 ➤Owner’s Guide
limited lifetime consumer warranty This Ungo Pro Security system is warranted against defects in material and workmanship. The main unit is covered by this limited lifetime warranty. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. This warranty is not transferable to any subsequent owner(s) of the product(s).
TO USE OF THE PRODUCT. BECAUSE SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR EXCLUSIONS OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE THE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE.
table of contents limited lifetime consumer warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .i standard configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 what is included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 system maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
standard configuration controls the Lock/Panic ON/Panic OFF function. controls the Unlock function. controls Silent Lock/Unlock and an Auxiliary Output. controls remote engine start. / controls Timer mode. + + 2 controls Turbo/Short Run. controls Channel 4 output.
what is included z Control module z Receiver/antenna z Two four-button remotes z Blue status LED indicator light z Push-button Override switch z Shut-down toggle switch important information Congratulations on the purchase of your remote engine start keyless entry system. Due to the complexity of this system, it must be installed by an authorized dealer only. Installation of this product by anyone other than an authorized dealer voids the warranty.
FCC/ID notice This device complies with Part 15 of FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device.
standard configuration Button The lock and panic functions are controlled by pressing on the remote for one second. Button The unlock function is controlled by pressing on the remote for one second. Button Silent Lock/Unlock and an optional auxiliary function are controlled by this button in conjunction with the or button. (An optional auxiliary function, such as trunk release, can be controlled by pressing this button for 1.5 seconds. The auxiliary output controls __________________________.
using your system warning! safety first The following safety warnings must be observed at all times: z Due to the complexity of this system, installation of this product must only be performed by an authorized dealer. z When properly installed, this system can start the vehicle via a com- mand signal from the remote. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage).
gear. This testing should be performed by an authorized dealer in accordance with the Safety Check outlined in the product installation guide. If the vehicle starts in gear, cease remote engine start operation immediately and consult with the authorized dealer to fix the problem. z After the remote engine start module has been installed, contact your authorized dealer to have him or her test the remote engine start module by performing the Safety Check outlined in the product installation guide.
locking Pressing for one second locks the doors (if the door locks are con- nected) and activates the starter kill. The horn will honk (if connected) and the parking lights will flash once to confirm arming of the system. While the system is locked, the status LED will flash once per second. The Starter Kill (if installed) will also prevent the vehicle’s starter from cranking. The system can also be programmed to arm the optional Starter Kill automatically (called Passive Mode).
unlocking Pressing for one second unlocks the doors (if connected). The horn will honk twice (if connected) and the parking lights will flash twice to confirm unlocking of the system. The optional Starter Kill will be deactivated. The status LED will turn off, unless the system is programmed for Passive Mode. In Passive Mode, the status LED will flash rapidly when the system is disabled.
override mode You can prevent your system from automatically activating the Starter Kill and locking the doors by using override mode. This is very useful when washing the vehicle or having it serviced. In override mode, the starter kill cannot be activated, even with the remote, but all convenience functions (door locks, remote engine start, etc.) will continue to work normally. To enter or exit override mode: 1. Turn the ignition on. 2. Turn the ignition off. 3.
remote engine start This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system. If interior heating or cooling is desired, the climate controls must be preset, and the fan blower must be set to the desired level prior to remote engine starting the vehicle. IMPORTANT! (1) This product is not for use in manual transmissions.
When you are ready to drive the vehicle: 1. Insert the ignition key and turn it to the RUN (not the START) position. 2. Press the brake pedal. Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down. While the vehicle is running during remote engine start operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shut-down inputs: z The brake pedal is pressed. z The hood is opened.
take-over mode The Override take-over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on. To perform Take-over mode: 1. Before turning off the engine, press and release on the remote twice in 3 seconds (or press and release the optional momentary switch).
3. Press and release the and buttons at the same time. 4. The lights will flash to indicate the remote engine start has entered short run turbo mode. 5. Turn off the key, the engine will keep running. 6. Exit and secure the vehicle. 7. The engine will turn off after the programmed run time. timer mode By pressing the remote and buttons the parking lights will flash 4 times and then start the vehicle and run for the set duration.
6. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires. important! Timer Mode should be used only in open areas. Never start and run the vehicle in an enclosed space such as a garage or carport. starter anti-grind circuity Whenever the vehicle is remote engine started, advanced anti-grind circuitry prevents the starter from engaging, even if the key is turned to the start position.
power-up This system will store its current state to non-volatile memory. If power is lost and then reconnected the system will recall the stored state from memory. This means if the unit is in override mode and the battery is disconnected for any reason, such as servicing the car, when the battery is reconnected the unit will still be in override mode. This applies to all states of the system including lock, unlock, and override mode.
z Ignition switch-controlled door-locking on or off. With this feature on, the doors will lock 3 seconds after the ignition key is turned on, and unlock when the ignition key is turned off. z Passive Locking or Active Locking (doors lock only with the remote). With Passive Locking, the vehicle doors lock automatically 30 seconds after the ignition has been turned off. Passive Locking can only be selected when the system has been programmed for Passive Mode.
glossary of terms Control Unit: The “brain” of your system. Usually hidden underneath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all system functions. Starter Kill: An automatic switch controlled by your system which prevents the vehicle’s starter from cranking whenever the system is activated. The vehicle is never prevented from cranking when the system is deactivated, in override mode, or if the starter kill switch itself fails.
convenience expansions Listed below are some of the many expansion options available for use with your system. Some options may require additional parts and/or labor. Please consult with your dealer for a complete list of options available for use with this system. Domelight Supervision: The domelight will illuminate for 30 seconds each time the system is disarmed using the remote. This is useful for seeing inside the vehicle at night prior to entering it.
Power Window Control: Power window control can be provided by one of two systems. The firsts system provides control that will roll up two windows automatically when the system is armed, or roll two windows down by using the remote. The second system will roll two windows both up and down. This second system also provides one touch switch operation. Progressive Door Unlocking: For added security, your system can be configured to unlock the driver’s door only, leaving the passenger doors locked.
notes 21
22
✂ QUICK REFERENCE GUIDE: ■ To lock the system press for one second. The doors will lock (if connected). The LED will begin to flash. The Starter Kill will prevent the vehicle’s starter from cranking if it has been installed. The vehicle’s horn (if connected) will honk and the parking lights will flash once to confirm activation of the system. To unlock using your remote ■ To unlock the system press for one second. The doors will unlock (if connected).
Get Started Get Protected Ungo Pro Security 661 W. Redondo Beach Blvd. Gardena, Ca. 90247 800-GO-CLARION © 2003 Directed Electronics, Inc.
